HP Indigo W7200 Blanket Creep Diagnosis and Correction - Page 4

Special jigs and tools, For second transfer (T2) and top dead point (TDP) calibration

Get HP Indigo W7200 PDF manuals and user guides View all HP Indigo W7200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

2 Special jigs and tools Graduated bubble level - accurate to 0.1 mm Flashlight Small telescopic mirror Tie-wraps (300 mm or longer) (x5) Web Handling System (WHS) in the Printing Engine Service Document (CA393-00590) For second transfer (T2) and top dead point (TDP) calibration Follow these steps for the second transfer and top dead point calibration. 1. Cut blanket - remove 15mm from both blanket sides Figure 2-1 Cut blanket, 15mm were removed from both blanket sides 2. TDP calibration jig CA045-15732 Figure 2-2 TDP jig CA045-15731 3. Filler gages single leaf set with 0.75 and 0.8 gages included in the set Figure 2-3 Feeler gauge set 2 Chapter 2 Special jigs and tools

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Special jigs and tools
2
Graduated bubble level - accurate to 0.1 mm
Flashlight
Small telescopic mirror
Tie-wraps (300 mm or longer) (x5)
Web Handling System (WHS) in the Printing Engine Service Document
(CA393-00590)
For second transfer (T2) and top dead point (TDP) calibration
Follow these steps for the second transfer and top dead point calibration.
1.
Cut blanket – remove 15mm from both blanket sides
Figure 2-1
Cut blanket, 15mm were removed from both blanket sides
2.
TDP calibration jig CA045-15732
Figure 2-2
TDP jig CA045-15731
3.
Filler gages single leaf set with 0.75 and 0.8 gages included in the set
Figure 2-3
Feeler gauge set
2
Chapter 2
Special jigs and tools