HP Elite Dragonfly G2 Maintenance and Service Guide - Page 48
Fingerprint reader board, Disconnect the cable from the ZIF connector on the system board
![]() |
View all HP Elite Dragonfly G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
5. Peel the extend cable off computer chassis to remove it (6). Reverse this procedure to install the extend cable. Fingerprint reader board To remove the fingerprint reader board, use this procedure and illustration. Table 5-7 Fingerprint reader board description and part number Description Fingerprint reader board Fingerprint reader bracket (available in Hardware Kit, models without WWAN) Fingerprint reader bracket (available in Hardware Kit, models with WWAN) Spare part number M42269-001 M42270-001 M48386-001 Before removing the fingerprint reader board, follow these steps: 1. Prepare the computer for disassembly (Preparation for disassembly on page 30). 2. Remove the bottom cover (Bottom cover on page 30). 3. Remove the battery (see Battery on page 31). Remove the fingerprint reader board: 1. Disconnect the cable from the ZIF connector on the system board (1). 2. Remove the Phillips M2.0 × 2.0 screw (2) that secures the fingerprint reader bracket to the computer, and then remove the bracket (3). 40 Chapter 5 Removal and replacement procedures for authorized service provider parts
![](/manual_guide/products/hewlettpackard-elite-dragonfly-g2-maintenance-service-guide-a57a3d7/48.png)