HP Desktop Pro 300 Maintenance and Service Guide - Page 20
Cleaning the keyboard, Cleaning the monitor, CAUTION
View all HP Desktop Pro 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Cleaning the keyboard Follow all safety precautions in General cleaning safety precautions on page 11 before cleaning the keyboard. To clean the tops of the keys or the keyboard body, follow the procedures described in Cleaning the computer case on page 11. When cleaning debris from under the keys, review all rules in General cleaning safety precautions on page 11 before following these procedures: CAUTION: Use safety glasses equipped with side shields before attempting to clean debris from under the keys. ● Visible debris underneath or between the keys may be removed by vacuuming or shaking. ● Canned, pressurized air may be used to clean debris from under the keys. Caution should be used because too much air pressure can dislodge lubricants applied under the wide keys. ● If you remove a key, use a specially designed key puller to prevent damage to the keys. This tool is available through many electronic supply outlets. CAUTION: Never remove a wide leveled key (like the space bar) from the keyboard. If these keys are improperly removed or installed, the keyboard may not function properly. Cleaning the monitor ● Wipe the monitor screen with a clean cloth moistened with water or with a towelette designed for cleaning monitors. CAUTION: Do not use sprays or aerosols directly on the screen; the liquid may seep into the housing and damage a component. Never use solvents or flammable liquids on the monitor. ● To clean the monitor body follow the procedures in Cleaning the computer case on page 11. Cleaning the mouse 1. If the mouse has an on/off switch, turn it off. 2. Wipe the body of the mouse with a damp cloth. 3. Clean the following components as directed: - Laser or LED-Use a cotton swab dampened with an appropriate cleaning solution (see Cleaning the computer case on page 11). Gently brush out any dust around the laser or LED, and then wipe again with a dry swab. Do not wipe the laser or LED directly with the swab - Scroll wheel-Spray canned, pressurized air into the gap between the scroll wheel and the click buttons. Do not blow air directly on one spot for very long or condensation can form. - Roller ball-Remove and clean the roller ball, remove any debris from the ball socket, wipe out the socket with a dry cloth, and reassemble the mouse. 12 Chapter 3 Routine care, SATA drive guidelines, and disassembly preparation