Harman Kardon BDS 770 Owners Manual - Page 18

BDS 270/BDS 570 Setting Up the Receiver EZ Set/EQ: The BDS receiver's EZSet/EQ™ system uses the supplied EzSet/EQ microphone to perform this important step automatically. Before beginning, be sure you have correctly connected your speakers to the BDS receiver. IMPORTANT: Press the remote's "Disc" input button before performing the EZ Set/EQ procedure. The EZ Set/EQ procedure is only available when the Disc input is selected. 1. Plug the supplied EzSet/EQ microphone into the BDS receiver's Headphone connector. 2. Place the microphone at ear height in your main listening position. 3. Press the remote control's Home button. The receiver's Home Menu screen will appear on the TV. 6. Press the right Cursor button to select EzSet/EQ, then use the cursor buttons to select the configuration of your speaker system. Audio Settings Tone Controls Audio Output Speaker Settings EzSet/EQ Off Manual Configuration 2.0 2.1 3.1 5.1 The EzSet/EQ automatic setup can calibrate the BDS system and configure the loudspeakers parameters automatically to get the best sound performance. 7. Press the OK button, then press it again to select Continue in the EzSet/EQ (Automatic Setup) box that appears. Home Menu Blu-ray Disc FM Radio HDMI input Component input Playlist Settings 1 / 5 HOME Exit Type: Settings OPTIONS Option 4. Use the Cursor and OK buttons to highlight and select Settings. The General Settings menu will appear. Audio Settings EzSet/EQ(Automatic Setup) Tone ControlsPlease plug theEmzicSroept/hEonQe into the system anOd ff Audio Output then place position. If it a SatuebMawaronloeufveaerll iaCstcoyononfuingreudcertaestdirio,esndeltisttheenilne2gv.e0l Speaker Settincgonstrol (on the Sub) to half. 2.1 Continue Cancel 3.1 5.1 The EzSet/EQ automatic setup can calibrate the BDS system and configure the loudspeakers parameters automatically to get the best sound performance. 8. Remain silent while the test noise plays through the speakers. As the test noise circulates among the speakers the screen will show which speaker is being tested. General Settings System Language Playback Parental Control Network Select to adjust general settings 5. Use the right Cursor button to select Audio Settings, then use the down Cursor button to select Speaker Settings. The Speaker Settings screen will appear. Audio Settings Tone Controls Audio Output Speaker Settings EzSet/EQ 2.0 Manual Configuration 2.0 Audio Settings EzSet/EQ(Automatic Setup) L C Testing... LS SUB Please keep room silent. The current testing speaker is L R RS 9. When the testing process is completed, the "Testing..." message on the screen will change to "All test done!" 10. Press the Clear/Exit button to exit the EzSet/EQ test procedure. NOTE: If the test fails, the "Testing..." message on the screen will change to "Test failed, please make sure the speaker is connected correctly and room is silent, then retest." Press the Clear/Exit button, make sure all speakers are correctly connected and perform the test again from Step 6. Make sure that the room remains silent during the test. Select to adjust speaker settings 18