Haier AU42NALEAA Service Manual - Page 67

>a__WcU[S^ a`V[e[a`Wc 4Installation of indoor unit In the case of new ceiling (1) Install unit temporally Put suspending bracket on the suspending bolt. Be sure to use nut and washer at both ends of the bracket. (2) As for the dimensions of ceiling hole, see paper pattern. Ask your real estate dealer for details. Center of the hole is marked on the paper pattern. Center of the unit is marked on the card in the unit and on the paper pattern. Mount paper pattern 5 onto unit using 3 screws 6 . Fix the corner of the drain pan at piping outlet. < After installation on the ceiling > (3) Adjust unit to its right position. (Refer to preparation for the installation-(1)) (4) Check unit's horizontal level. Watert pump and flating switch is installed inside indoor unit, check four corners of the unit for its level using horizontal compartor or PVC tube with water. (If unit is tilting against the direction of water drainage, problem may occur on floating switch, causing water leakage.) (5) Remove the washer mounlting 2 , and tighten the nut above. (6) Remove the paper pattern. Nut (Prepare in feild) In the case of ceiling already exists Washer (Prepared in feild) (1) Install unit temporally Put suspending bracket on the suspending bolt. Be sure to use nut and washer at both ends of the bracket. Fix the bracket firmly. (2) Adjust the height and position of the unit. (Refer to preparation for the installation (1) ). (3) Proceed with 3 and 4 of "In the case of new ceiling". Suspending bolts Fasten (double nuts) Level Polythene pipe Insert Washer fixing pad (prepared in feild) [ secure the washer firmly] Screws at the piping outlet is fixed at the corner of drain pan. Center of ceiling hole Paper pattern Paper pattern5 Screw (accessory) [Fix the paper pattern] Screw (accessory) -67-