GE PV970NSS Use and Care Manual - Page 20
Installation Instructions, INSTALLATION-RECIRCULATING, WARNING
UPC - 084691174745
View all GE PV970NSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installation Instructions INSTALLATION-RECIRCULATING 4 MOUNT THE HOOD WARNING: 2 people are required to lift and position the hood onto the mounting screws. • Lift the hood onto the mounting screws. • If using a wall fastener, make sure the washer is in front of the flange and not behind it. Check with a level before tightening screws. • Install lower screws to pull the hood tight against the wall. Tighten screws 5 SIZE AND CUT DUCT PIECE • Measure from the bottom of the air deflector to the top of the hood as shown. Reduce that dimension by 1" to facilitate installation. The duct will cover and overlap the deflector and the exhaust outlet in the hood. • Remove the air deflector from the duct cover bracket . Measure length Duct length Bottom screw location Install screws • Cut the duct piece to size and slip onto the bottom of the deflector. • Place the assembled deflector and duct over the exhaust outlet. • Hold the assembly against the duct bracket. • Drive 2 screws into each side of the bottom of the deflector and into the bracket. • Use duct tape to seal duct to the deflector and at the exhaust outlet. Deflector 20