GE JVX3240DJWW Use and Care Manual - Page 17
Remove Electrical, Knockouts, Remove Junction Box, Remove Duct Knockouts, For Vented Installation,
![]() |
View all GE JVX3240DJWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
INSTALLATION PREPARATION Installation Preparation 4 REMOVE ELECTRICAL KNOCKOUTS Use a flat blade screwdriver, remove the appropriate electrical knockout from the back or the top of the hood. 6 REMOVE DUCT KNOCKOUT(S) FOR VENTED INSTALLATION Determine which ducting option to use. Using a flat blade screwdriver, remove the appropriate duct knockout(s) from the top or back of the hood. 3 1»4" x 10" Rectangular vertical discharge. Remove top rectangular duct knockout only. 7" Round vertical discharge. Remove semi-circular duct knockout and top rectangular duct knockout. 5 REMOVE JUNCTION BOX Remove junction box from inside the hood. Set the junction box and mounting screws aside. Junction Box Screws 3 1»4" x 10" Rectangular horizontal discharge. Remove rear rectangular duct knockout only. NOTE: If the hood is to be installed in a recirculation, non-vented ductless manner, do not remove any venting knockouts. NOTE: For an ENERGY STAR® model, unit must be vented mode to be considered ENERGY STAR® certified. 7 ATTACH DAMPER/DUCT CONNECTOR Attach damper/duct connector over knockout opening with two or four (D) screws. Make sure damper pivot is nearest to top/back edge of hood. Remove any packaging tape to allow damper to move freely. Tape 7RSEDFN edge Damper (vertical discharge position shown) Rectangular Ducting 7" round exhaust adaptor 49-80783-3 Round Ducting 17
![](/manual_guide/products/general-electric-pvx7360sjss-use-care-manual-ecb9904/17.png)