GE JVM2052DNWW Installation Instructions - Page 17

Installation Instructions B4 ADAPT MICROWAVE OVEN BLOWER FOR OUTSIDE BACK EXHAUST (cont.) 3 Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. BEFORE: Fan Blade Openings Facing Up End B End A 4 Rotate the unit so that the exhaust ports face the rear of the cabinet. When you insert the blower unit, the blower wire must be as shown. Blower unit Exhaust ports 5 Place the blower unit back into the cabinet. Check that the exhaust ports face toward the rear of the cabinet. Exhaust ports WARNING: Risk of electric shock can cause injury or death. Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven. 6 Reattach the blower plate to the cabinet so the exhaust ports and blower plate opening are aligned. Attach with 2 blower unit mounting screws and then 3 blower plate mounting screws. Blower unit Blower plate mounting screw (3 screws) Blower plate Blower unit exhaust ports Back plate Blower unit mounting screw (2 screws) 7 Attach the exhaust adapter to the rear of the oven by sliding it into the guides at the top center of the back of the oven. Adapter Back of Microwave Oven Guide Guide Locking Tabs Push in securely until it is in the lower locking tabs. Take care to ensure that the damper hinge is installed so that it is at the top and that the damper swings freely. 17