GE CGU366SEHSS Installation Instructions - Page 13
Tools And Materials Required, To 36 Adjustable Backsplash Not Included, Install The Wall Support
![]() |
View all GE CGU366SEHSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ZXADJB30PSS, ZXADJB36PSS, ZXADJB48PSS Accessory Installation $&&(6625,(6³" TO 36" ADJUSTABLE BACKSPLASH (not included) WARNING: To prevent ignition of combustible materials, the entire back wall above the range must be protected by a backsplash constructed of noncombustible material. BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT: Save these instructions for local inspector's use. IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer. NOTE TO CONSUMER: Keep these instructions with your Owner's Manual for future reference. • This backsplash adjusts to fit the space between the top of the range and the bottom of the hood, from 30" Min. to 36" Max. height. • Maximum shelf load-bearing weight is 40 lbs. INSTALL THE WALL SUPPORT PANELS WARNING: The wall support panels must be securely fastened to the wall. Failure to do so could result in damage or personal injury. IMPORTANT: This backsplash is designed to cover the wall between the bottom of the hood and the top of the range. The vent hood should be installed over the rangetop or range before installing this backsplash. • Install and level the Range/Rangetop according to the product installation instructions. • Remove backsplash packaging and protective film. • Locate wall studs on each side. Where studs are not available, plan to use wall anchors (not provided). • Use a level to pencil 2 horizontal lines on the wall, one 1/8" below the vent hood and the other 1/8" above the Range/Rangetop. This 1/8" space allows the cover panels to overlap the wall supports. • Secure the top wall support panel to the wall with 4 wood screws, through the outermost studs. • Use 4 wood screws to secure the bottom wall support panel. The center slot should be positioned at the top. The gap between the top and bottom support panels will be covered by the top cover with shelf. Secure the top panel to 1/8" the wall with 4 wood screws TOOLS AND MATERIALS REQUIRED • Gloves to protect against sharp edges • T-15 and #2 Phillips screwdrivers • Drill with 3/32" and 9/64" bits • Safety glasses Top Wall Support 1/8" Center Arrow Wood Screws Wood Secure the Screws bottom panel to the wall with 4 wood screws • Level • Pencil Top Cover with Shelf This Kit Includes • Top wall support • Bottom wall support • Top cover with shelf Bottom Cover • Bottom cover • Hardware package with Bottom Wall Support - 9 Stainless Steel Torx 15 #8 self-tapping screws - 9 Phillips #2 pan head wood #10 screws - 3 Stainless Steel #2 truss head #10 screws (for alternate installation method) Hardware Package 13
![](/manual_guide/products/general-electric-cgu366sehss-installation-instructions-e167ed9/13.png)