Garmin Tread XL - Baja Chase Edition Owners Manual - Page 67
Connecting a Control Input, Connecting the Device to Vehicle Power, Garmin PowerSwitch device.
![]() |
View all Garmin Tread XL - Baja Chase Edition manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
NOTICE Do not connect the accessory ground wires to the ground terminal (GND) on the Garmin PowerSwitch device. Failure to heed this notice could result in personal or property damage, or negatively impact device functionality. 3 Verify that all electrical connections are tight and will not come loose during use. Connecting a Control Input You can connect to the control terminals to enable the Garmin PowerSwitch device to turn on customizable outputs. For example, you can connect your vehicle ignition switch to a control input terminal to turn on accessories automatically each time you start your vehicle. The control terminals detect a signal from 3.3 V to 18 V. You can configure output functions with the Garmin PowerSwitch app. Connect the control wire from the control source in your vehicle to one of the two control terminals on the Garmin PowerSwitch device. Connecting the Device to Vehicle Power Before you can connect the device to vehicle power, you must remove the warning tag from the +12V terminal on the device. You should always confirm all electrical connections are secure and will not come loose while operating the device. 1 Connect the large ring end of the included ground wire to the negative terminal on the vehicle battery. 2 Connect the small ring end of the ground wire to the GND terminal on the device. 3 Connect the small ring end of the included 12V cable to the +12V terminal on the device. Appendix 61
![](/manual_guide/products/garmin-tread-xl-baja-race-edition-owners-manual-5a4b359/67.png)