Ganz Security PT127N-XT Manual - Page 40

G Pattern Setup PATTERN SETUP PATTERN NO. 1 UNDEFINED CLR PATTERN CANCEL RUN PATTERN BACK EXIT ‰ Pattern Edit EDIT PATTERN 1 OSD MENU 4 z Pattern Number z Clear Pattern z Run Pattern z Edit Pattern [1~4 ] Selects a Pattern number to edit. If the selected pattern number is not defined, "UNDEFINED" will be displayed under the selected pattern number. [CANCEL/OK] Deletes the data of the selected pattern. Runs the Pattern for the test purposes to check if it works properly. Edits the selected pattern. ྙGWith the Joystick of your controller, move the camera to the start position with an appropriate zoom magnafication. To start the pattern recording, press NEAR key. To exit, press FAR key. MOVE TO START POSITION [NEAR:START /FAR:CANCEL] EDIT PATTERN 1 [NEAR:SAVE /FAR:DELETE] 0/0/x1/N ྚGMove camera with joystick of controller or run preset function to memorize the path (mostly curve path) in the selected pattern. The movement by Joystick and preset movement will be memorized in a pattern. After a pattern is programmed, the remaining storage is displayed in progress bar on the screen. ཝGTo save the data and exit, press NEAR key. To cancel saving the data and delete the data, press FAR key.G GSpeed Dome Camera Instruction Manual 40/48