Frigidaire FHTE103WA2 Complete Owners Guide - Page 17

17 OPERATING INSTRUCTIONS DO THIS: PRESS FILTER RESET BUTTON TIMER: DELAY STOP/START FEATURE: Setting combination of "delay stop turn off delay start" or "delay start turn on delay stop" is workable. Both "timer o " indicator and "timer on" indicator will illuminate then. The timer setting can be canceled by either pressing and holding the timer button for 2 seconds, or pressing the power on/o button at any time to turn o the unit directly. HEATING FEATURE: THEN DO THIS: PRESS UP/DOWN BUTTONS FIRST DO THIS: PRESS TIMER BUTTON DO THIS: PRESS MODE BUTTON CHOOSE DRY YOU WILL SEE: YOU WILL SEE HOW MUCH TIME IS CHOSEN: To delay stop(or start), press the Timer button when the unit is power-on(or power-o ), then the "timer o " indicator(or "timer on" indicator) will illuminate. Then adjust timer setting, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The setting will be confirmed automatically in 5 seconds, then the control will count down the time(8h, 7.5h, 7h, etc.) left, and all other settings will remain the same as they were before the timer setting is confirmed, until stop(or start). Note: This feature can be used with any combination of FAN Speeds (Low speed only on 115V models), Timer, or Sleep Modes. When in the "Heat" mode, the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 62 °F(17 °C) and 86 °F(30 °C). When the room set temperature is satisfied, the fan will cycle o and on to circulate and sample the room air. Eco feature is invalid in heating mode.