Frigidaire FHSC102WB1 Installation Instructions - Page 4
Installing Unit in a Sliding Window
![]() |
View all Frigidaire FHSC102WB1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Installation Instructions Installing Unit in a Sliding Window: 4 Attach support brace to platform as shown (FIG.6). Use adjustment bolt and hex flange nut to complete assembly. Choose slot and adjustment bolt hole locations that will create a 45 degree angle between platform and support brace. Try assembly in the window to determine if platform will rest properly, and allow proper slope (3/16″ lower on out side). FIG.6 Platform Assembly NOTE: If you are planning to use a siding-protection board (see Step 8) on the outside of your house, hold board in place when testing assembly in window. 5 Measure, and lightly mark a line 8-11/16″ from window jamb: 1/4″ (6mm) HEX FLANGE NUT 8-11/16″ inches FIG.7 NOTE: If any sash stop protrudes more than 1″ from the side window jambs, the 8-11/16″ measurement must be increased accordingly (FIG.7). Screen and storm window frames may also require adjustments to the measurement. 6 Center platform assembly on the line with inside platform tab pressed against inside edge of window track as shown (FIG.8A, FIG.8B). Using the holes in the platform as a guide, mark and drill two 9/64″ diameter holes. Drill holes in either track or stool. For vinyl-clad windows, you need to install the support bracket on the window track before you install the platform. Follow the instructions below to do that. 1. Place the support bracket on the window sill as shown (FIG.8C). Using the holes in the support bracket as a guide, mark and drill two 1/8" diameter holes. 2. Follow Step 7 to applly the track seal on the room side of window track. 3. After applly the track seal, use two 3/8" screw (item 17) to fixing the support bracket. Make sure the support bracket is level form side to side. Proceed to Step 9 after you finish fixing the support bracket. 7 Peel off protective backing from track seal. Apply seal to room side of window track (FIG.9). Center of seal strip should coincide with the line marked in Step 5. The two screw holes drilled in Step 6 should be directly above seal strip in the inner track. 8 Securely attach a siding-protection board to side of house (FIG.10). NOTE: Siding-protection board should be long enough to span 2 wall studs. FIG.8C 8-11/16″ inches FIG.9 Apply track seal to window side of track. FIG.8A Center platform assembly on the line with platform tab pressed against window track Alternate screw location (depending on the inner sill depth) Platform tab FIG.8B window track window seal FIG.10 Alternate the screw location (depending on the height of the sill) 4 Inside wall of house Siding-protection board
![](/manual_guide/products/frigidaire-ffrs1022re-installation-instructions-ff4295c/4.png)