Frigidaire FFGW2426UB Installation Instructions - Page 9
Check Operation
View all Frigidaire FFGW2426UB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
GAS WALL OVEN INSTALLATION INSTRUCTIONS Observe the oven burner flame to determine if it is right. It should be steady with a blue cone approximately 1" long and should not extend out over the edges of baffle. For LP Gas, this will most likely occur when the air adjustment shutter is completely open. Turn Oven Temperature to 300°F and allow oven burner to cycle on and off. To replace storage drawer, reverse steps taken for removal (see the Use and Care Guide for complete instructions). Replace oven racks. Model and Serial Number Location The serial plate is located on the left side inner trim of the oven. When ordering parts for or making inquires about your wall oven, always be sure to include the model and serial numbers and a lot number or letter from the serial plate of your appliance. Your serial plate also tells you the rating of the burners, the type of fuel and the pressure the wall oven was adjusted for when it left the factory. 11. Check Operation Refer to the Use and Care Guide packaged with the wall oven for operating instructions and for care and cleaning of your appliance. Do not touch the oven burners. They may be hot enough to cause burns. 1. Check the Igniters (some models) Operation of electric igniters should be checked after oven and supply line connectors have been carefully checked for leaks and oven has been connected to electric power. 2. Oven Igniter System Close the door and turn the Oven Temperature to 300°F. In approximately 60 seconds, the burner should ignite and stay on until oven reaches 300°F. Burner should then cycle on and off to maintain an average temperature of approximately 300°F. When All Hookups are Complete Make sure all controls and programmable timer are left in the OFF position. Reset all controls to the "OFF" position after using a programmable timing operation. • Stepping, leaning or sitting on the oven door or drawer can result in serious injuries and also cause damage to the appliance. • Be sure to keep appliance clear of combustible materials, gasoline and other flammable vapors and liquids. Before You Call for Service Read the Avoid Service Checklist and operating and cleaning instructions in your Use and Care Guide. Check to make sure the house fuse or circuit breaker for your wall oven is not blown or open. Care, Cleaning and Maintenance for Wall Ovens If removing the wall oven is necessary for cleaning or maintenance, shut off gas supply. Disconnect the gas and electric supply. Remove the installation screws from front frame and lower trim. Pull out only as far as necessary to disconnect the electric supply line. After disconnecting the gas and electric supply, finish removing the unit for servicing and cleaning. Reinstall in reverse order and make sure that appliance is level; check gas connection for leaks. 9