Frigidaire FFGW2426UB Installation Instructions - Page 4
Alternate construction, Adjusting Oven Height
![]() |
View all Frigidaire FFGW2426UB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
GAS WALL OVEN INSTALLATION INSTRUCTIONS 3. Alternate construction Installation Instructions for installing a 1½ cavity oven into an existing 2 cavity opening with dimen- sions 42-1/8" height by 22 ½" Width. 42 1/8" (107 cm) 22 1/2" (57.2 cm) Hole for Cord 4. Adjusting Oven Height Remove and lay aside the lower vent decorative trim that is taped to the side or to the top of the oven. The decorative trim will be fastened to the lower front of the oven after it has been installed in the cabinet. There is a 1 ½" height adjustment on models with extension panel (see Figure 5). With this adjustment and a ½" trim overhang, a unit can be installed in existing openings 37 ½" to 39" high. Wood runner Height adjuster Figure 4 Plywood filler • If width opening is too wide to secure unit to cabinet with mounting screws, add plywood filler strips. • If height opening is at 42-1/8", lower height adjuster 1" (see section 4) and secure two 2" X 4" X 22" wood runners on each side at bottom of opening (see Figure 4). • The decorative lower trim (not shown) can be installed to hide the gap under the unit. It should overlap by ¼" the front of the cabinet at bottom of cutout (see step 2 of section 5). Adjustment Holes Extension Panel Mounting Screws Figure 5 4
![](/manual_guide/products/frigidaire-ffgw2426us-installation-instructions-d640a13/4.png)