Frigidaire FFET2726TB Complete Owner s Guide - Page 22
Setting Self Clean, Self Clean
View all Frigidaire FFET2726TB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
SETTING OVEN CONTROLS Setting Self Clean The Self Clean key controls the self-cleaning feature. If you are planning to use the oven directly after a self-clean cycle remember to allow time for the oven to cool down and the oven door to unlock. This normally takes about one hour. A 3 hour self-clean cycle will actually take about 4 hours to complete. It is recommended to use a 2 hour self-clean cycle for light soils, a 3 hour cycle for average soils, and a 4 hour cycle for heavy soils. To set the controls for a 3 hour self-cleaning cycle to start immediately and shut off automatically: 1. Be sure the clock is set with the correct time of day and the oven door is closed. 2. Press Self Clean. CLn and 3:00 HR will show in the display. The control will automatically clean for a 3 hour period (default self-cleaning cycle time). If a 2 or 4 hour clean time is desired, press Self Clean multiple times to toggle between 2, 3, or 4 hours. 3. Press START. door Loc will appear, a beep will sound, and the word DOOR and the lock icon will flash; CLn will remain on in the display. 4. As soon as the control is set, the motor driven oven door lock will begin to close automatically. Once the door is locked, the DOOR indicator light and lock icon will stop flashing and remain on, and the oven icon will appear in the display. Allow about 15 seconds for the oven door to lock completely. When the self-clean cycle is completed: 1. HOT will appear in the display. The time of day, the word DOOR, and the lock icon will remain in the display. 2. Once the oven has cooled for approximately 1 hour, door OPn will appear, and the word DOOR and the lock icon will flash until the door unlocks. The door can be opened, and the display will show the time of day. To stop or Interrupt a self-cleaning cycle: If it becomes necessary to stop or interrupt a self-cleaning cycle due to excessive smoke or fire in the oven: Press OFF. . NOTE When self clean is active you may check the time remaining by pressing the Self Clean once. The remaining time will appear in the display momentarily before reverting back to the time of day. If your clock is set with the (default) 12 hr display mode, the Delay Start for a Self Clean can only be programmed to start up to 11 hours and 59 minutes after the time showing in the display (be sure to set the clock to current time before programming a delay start). To set a Delay Start Self Clean to begin 12 or more hours (maximum is 23 hours and 59 minutes) after the time of setting, be sure to first set the control in the 24 Hr display mode. If Self Clean was active and then interrupted by a power failure or cancelled before the oven was thoroughly cleaned, it may be necessary to run another Self Clean cycle. If the oven temperature was high enough when Self Clean was interrupted the oven control may not allow another Self Clean cycle to be set for up to 4 hours. 22