Fellowes 130C Manual - Page 4
Cleaning Auto-start Infrared Sensors, Oiling Shredder, Sleep Mode Operation - bags
View all Fellowes 130C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Advanced product features SilentShred™ Technology SilentShred™ noise quality shreds without noisy disruptions. Energy Saving Sleep Mode Feature shuts down the shredder after 2 minutes of inactivity SLEEP MODE OPERATION Feature shuts down the shredder after 2 minutes of inactivity WHEN IN SLEEP MODE 1 2 To get out of sleep, open or Insert paper lid and load paper For more information about all of Fellowes Advanced Product Features go to www.fellowes.com PRODUCT MAINTENANCE OILING SHREDDER All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin. FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE 1 2 3 Cleaning Auto-Start Infrared Sensors Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: the paper detection sensors is located in the center of the paper entry). TO CLEAN THE SENSORS 1 2 3 4 5 Open lid *Carefully apply oil Close lid. Press and across cutters (do not . hold forward ( ) get oil in paper tray) 2-3 seconds *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250 Turn off and unplug shredder Open lid Locate Auto-start infrared sensor Dip cotton swab in rubbing alcohol Using cotton swab, wipe away any contamination from the paper sensors TROUBLESHOOTING 15 Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will .not operate for the duration of the recovery time. Remove Paper: When illuminated, press reverse ( ); open lid and remove paper. Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36053. Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding. * Shredder will not run when lid is open. MISALIGNED PAPER 1 2 If paper is not shredding through auto feed tray, check position of paper. 4 Paper should be flat and aligned with front of paper tray.