Fantec QB-35RFEU3 Manual - Page 4
Setup
View all Fantec QB-35RFEU3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
D. Take the transport paper board out of the device. E. Slide 4 HDDs into the chassis and make sure they are securely installed in order from up to down. F. Adjust the metal frame that was removed in Step C. Please make sure the bottom of the frame stays inside the track before closing the cover. SETUP RAID mode setup First install the HDD from up to down in the enclosure. Power on the device, press RAID button for 3 seconds until LED flashes. Press it again, select the RAID mode you want to use and press the Confirmation Button on the rear panel till the device shuts down. Power the device on again and the RAID mode setup is completed. : Supported : N/A No. of HDDs RAID MODE RAID 0 (Spanning) RAID 0 (Striping) RAID 1 (Mirroring) RAID 3 RAID 5 RAID 10 2xHDD 3xHDD 4xHDD G. Connect the power supply to the device, plug in either USB, Firewire or eSATA cable in the rear panel and power on the device. H. Set up RAID Mode. EN - 05/28 RAID mode confirmation button EN - 06/28