Epson V11H303020 User's Guide - Page 57
consumption and fan noise. Select, to project
UPC - 010343868175
View all Epson V11H303020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
3. Press Enter. Then use the up and down arrow buttons and the Enter button to set the following options: ■ Keystone Adjusts a distorted image from a trapezoid shape to rectangular. ■ Auto Keystone Automatically adjusts a distorted image from a trapezoid shape to rectangular when the projector's foot is extended or retracted. (Not available when you're projecting from the ceiling or using rear projection.) Select On or Off. ■ Operation Lock Disables all projector buttons (Full Lock) or all the buttons except the P Power button (Operation Lock). You can still operate the projector from the remote control. Changes to this setting take effect after you restart the projector. (After you turn off the projector, wait for the PPower light to turn a steady orange before turning it on again.) ■ Brightness Control Select Low lamp brightness when the projection is too bright for the room. The Low setting also reduces electricity consumption and fan noise. Select High to project the maximum brightness. (Also check the Brightness setting in the Image menu; see page 53.) ■ Volume Adjusts the volume. ■ Remote Receiver Deactivates the projector's front and/or back sensors that detect signals from the remote control. This may be necessary to prevent interference from bright fluorescent lights. ■ Test Pattern Displays a test pattern to assist you in focusing and zooming the image, and correcting the image shape. (To cancel the displayed test pattern, press Esc.) 4. When you're finished, press Esc or Menu. note To cancel the Operation Lock function from the projector, press the Enter button for about seven seconds. Fine-tuning the Projector 57