Epson TM-U220 Guide for right side up printing - Page 13

Confidential GS ( z nL nH 0 E [Name] End reverse block [Format] ASCII GS ( z nL nH 0 E Hex 1D 28 7A nL nH 30 45 Decimal 29 40 122 nL nH 48 69 [Range] nL = 2 nH = 0 [Description] ï Defines the end of a block of text to be printed in reverse order. Printable data received between the ìstart reverse blockî command and this command will be printed in reverse order. [Note] ï Data received after this command will be processed normally, and will not be printed in reverse order. ï This command is enabled only when processed at the beginning of the line. If this command processed at any other point, the printed result isnít guaran- teed. ï When DIP switch 1-1 is ON, donít use this command. If you do so, the printing isnít guaranteed. GS V m GS V m n (Function A) (Function B) Note: This command is a little changed for right side up printing from original command which is described in the ESC/POS Application Programming Guide. [Name] [Format] [Range] [Description] End reverse block and cut paper ASCII GS V m Hex 1D 56 m Decimal 29 86 m ASCII GS V m Hex 1D 56 m Decimal 29 86 m (Function A) m = 0, 1, 48, 49 (Function B m = 65, 66 0 ≤ n ≤ 255 (Function A) n (Function B) n n ï Defines the end of a block of text to be printed in reverse order, and performs a cut in the specified mode as following. ï Printable data received between the "start reverse block" command and this command will be printed in reverse order. Rev. A 5