Epson TM-T88IV UB-U05 Users Manual - Page 3

UB-BOARD Replacing Procedure (For UB-U05) Copyright 2003 by Seiko Epson Corporation, Nagano, Japan Printed in China EMC Standard Applied Product Name: UB-U05 Model Name: M186A The following standards are applied only to the printers that are so labeled. (EMC is tested using the EPSON AC Adapters and TM series printer.) Europe CE marking North America Japan: EMI: VCCI Class A Oceania EMI: FCC/ICES-003 Class A EMC: AS/NZS 3548, CISPR22 Class A WARNING The connection of a non-shielded interface cable to this board will invalidate the EMC standards of this device. You are cautioned that changes or modifications not expressly approved by SEIKO EPSON Corporation could void your authority to operate the equipment. CE Marking The printer conforms to the following Directives and Norms: Directive 89/336/EEC EN 55022 Class A EN 55024 IEC 61000-4-2 IEC 61000-4-4 IEC 61000-4-6 The printers in which this board is installed do not conform to the following: Directive 90/384/EEC EN 45501 IEC 61000-4-3 IEC 61000-4-5 IEC 61000-4-11 WARNING M186A is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. FCC Compliance Statement For American Users This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. For Canadian Users This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. This manual describes how to replace the currently installed UB-BOARD with a UB-U05 board in TM series printers designed for this board. Precautions • Disconnect the power supply from the printer before you remove or install a UB-U05; otherwise you may damage the UB-U05 and the printer. You must disconnect the power supply because the electrical current is flowing in some parts of the printer circuit even when the power switch is turned off. • Wear a grounded wrist strap when handling the UB-U05 to prevent damage from static electricity. • To avoid contamination, do not touch the UB-U05 connector. Operation Environments and Models • Operation Environments (*1): Hardware: USB compliant PC OS: Windows 98 (Second Edition is recommended.) or later Software: You need device driver if you use the UB-U05. Please ask your dealer how to get the device driver for the UB-U05 and how to install it. (*1) Even if the above operation environments are satisfied, your system may not work properly, depending on the devices connected to your system. • Supported printers: There is limitation of the printers that can be used with the UB-U05. Please ask your dealer for the printer information. 3