Epson TM-T88IV UB-R04 Technical Reference Guide - Page 36
Initializing the UB-R04
View all Epson TM-T88IV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Initializing the UB-R04 The UB-R04 setting can be reset to the default using the following method. The default setting is as follows. Communication standard: 802.11b/g/n Network mode: Infrastructure mode SSID: EpsonNet Encryption Type: WPA-PSK(AES) Passphrase: EpsonNet IP address: 192.168.192.168 Subnet mask: 255.255.255.0 * You can connect to a WPA2-PSK (AES) access point using the settings above. 1 Set the roll paper for the TM printer to print. 2 Turn off the TM printer. 3 While holding down the Push button, turn the TM printer on. Push the Push button using an extended paper clip or a pen point. 4 Wait for about 30 seconds without letting the Push button up. A receipt as shown below is printed. Do not turn the printer off until the initialization is completed. 36