Epson TM-H6000V Technical Reference Guide - Page 155

Appendix Notes on Wi-Fi connection Because not all the combinations of the printer and Wireless LAN units have been checked for operation, the operation of the printer in combination with all the Wireless LAN units is not guaranteed. Especially in the adhoc mode, the printer may not operate normally, depending on the combination of the device to connect with. Be sure to carry out evaluation of the operation before use. Notes on use  When you initialize or change the printer settings, the printer is reset to reflect the settings. It may take about 1 minute depending on the network settings or environment. Also, your application may indicate power off during the time waiting for reset. In that case, wait for about 1 minute, and then reconnect to the printer.  Where Wi-Fi communication is in heavy traffic, your application may falsely recognize that the communication is disconnected and indicate power off due to response delay. In that case, disable Power Save to improve the trouble. Bluetooth Interface  Countries where Bluetooth can be used are limited. Since notes are provided for each country, check the sheet supplied with the product.  The circuit board installed in the UIB interface section is for Bluetooth models only. This cannot be replaced so do not remove it. Specification  Bluetooth 3.0 (EDR supported)  Bluetooth Power Class 2  Built-in antenna Default Settings Setting Contents Bluetooth communication settings Setting Items Default Settings Bluetooth passkey "0000" Bluetooth device name "TM-H6000V_xxxxxx" (Where xxxxxx is the last six digits in the serial number) Bundle Seed ID "TXAEAV5RN4" Enable/Disable auto reconnect to "1" (Enable) iOS device Bluetooth Security Low 155