Epson ActionPC 7300 User Manual - Page 117
Connecting the Drive and Power Cables, Locate pin 1 on the drive connector next to the power
![]() |
View all Epson ActionPC 7300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Connecting the Drive and Power Cables * If your IDE device cable is already connected to the IDE interface, follow the steps in this section to connect the cable to the drive. Follow these steps to connect the drive and power cables: 1. Locate the connector at the end of the ribbon cable. 2. Locate pin 1 on the drive connector next to the power connector. 3. Position the connector on the cable so that the red wire aligns with pin 1 on the drive. pin 1 Installing and Removing Slimline Drives 5-19
![](/manual_guide/products/epson-actionpc-7300-user-manual-ac43ae1/117.png)
Connecting the Drive and Power Cables
*
If your IDE device cable is already
connected
to the IDE
interface, follow the steps in this section to connect the cable to
the drive.
Follow these steps to connect the drive and power cables:
1.
Locate the connector at the end of the ribbon cable.
2.
Locate pin 1 on the drive connector next to the power
connector.
3.
Position the connector on the cable so that the red wire aligns
with pin 1 on the drive.
pin 1
Installing and Removing Slimline Drives
5-19