Epic Fitness El 2790 Elliptical English Manual - Page 7
Tip: To prevent the Wire Harness 110
View all Epic Fitness El 2790 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Insert the Rear Frame (2) into the Front Frame (1); make sure that the Ramp (3) is on the 3 Lift Roller (12). Attach the Rear Frame (2) with five M8 x 19mm Screws (82) and five M8 Split Washers (83). 82 83 12 3 1 2 83 82 83 82 4. Have a second person orient the Upright (4) as shown and hold it near the Front Frame (1). 4 Locate the wire tie in the Upright (4). Tie the lower end of the wire tie to the Wire Harness (110). Next, pull the upper end of the wire tie until the Wire Harness is routed completely through the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness (110) from falling into the Upright (4), secure the Wire Harness with a rubber band or tape. Tip: Avoid pinching the Wire Harness (110). Slide the Upright (4) onto the Front Frame (1). Attach the Upright (4) with four M8 x 19mm Screws (82) and four M8 Split Washers (83); do not tighten the Screws yet. Avoid pinching the Wire Harness (110) Wire Tie 82 83 82 Wire Tie 4 83 82 110 1 7