Electrolux EW30CC55GW Complete Owner's Guide (English) - Page 19

Setting Surface Controls 19 OPERATING THE DUAL SURFACE RADIANT ELEMENT Both the 30" and 36" cooktops are equipped with dual radiant surface element located as shown in Figs. 1 & 2. A touch key pad on the element controls is used to select one of the 2 positions of the element. Symbols and indicator lights on the control panel are used to indicate which coil of the dual radiant element will heat. The symbol indicates that only the INNER coil will heat (Fig. 3). The symbol indicates that both INNER and OUTER coils will heat (Fig. 4). You may switch from either coil setting at any time during cooking. To Operate the Dual Surface Element: 1. Place correctly sized cookware on the radiant surface element. 2. Touch and hold the key pad until a beep sounds. The power POWER indicator light above the will turn ON. Note: If no other key pad POWER is touched within 20 seconds the request to Power ON the cooktop will clear. 3. Touch and hold the pad for the dual element position until a beep ON OFF is heard. Note: If no further pads are touched within 10 seconds the request to power the element ON will clear. 4. Select the INNER (Fig. 3) or INNER and OUTER (Fig. 4) to heat by POWER lock warm - lo ON OFF hi + - lo hi + - lo hi + Fig. 1 - lo hi + timer POWER lock warm - lo ON OFF hi + - lo ON OFF hi + - lo ON OFF hi + - lo ON OFF hi + - lo ON OFF hi + timer touching the key pad. size Fig. 2 5. Touch pad once to turn ON the power level to HI or touch pad once for power level to Lo. 6. Each touch of the or pad will increase or decrease the power level. Lo is the lowest power level available. Note: The power level may be adjusted at any time while the element is ON. 7. Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. 8. When cooking has been completed touch the pad once to turn the element OFF ON OFF and if no other surface element is used touch the key pad to turn off the POWER cooktop.Note: The Hot Element (HE) message will be showed on display for each element until the heating surface area has cooled sufficiently. Fig. 3 ! CAUTION Radiant surface elements may appear to have cooled after they have been turned OFF. The Hot Element (HE) message will be showed and will continue to display until the glass cooktop has cooled down to a moderate level. The glass surface may still be hot and burns may occur if the glass surface is touched before the display has turned OFF. Fig. 4