Dewalt DW45RN Instruction Manual - Page 9
OPERATION, Preparing the Tool, Loading the Tool Fig. 2-4 - trigger valve
View all Dewalt DW45RN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
English 3. To install a 3/8" (9.5 mm) fitting: screw the fitting into the 3/8" (9.5 mm) adapter and then into the air inlet of the tool and tighten firmly. OPERATION Preparing the Tool WARNING: Read the section titled Important Safety Instructions at the beginning of this manual. Always wear eye and ear protection when operating this tool. Keep the nailer pointed away from yourself and others. For safe operation, complete the following procedures and checks before each use of the nailer. NOTICE: To reduce the risk of damage to the tool, only use DeWALT pneumatic tool oil or a non-detergent SAE 20 weight oil. Oil with additives or detergent will damage tool parts. 1. Before you use the nailer, be sure that the compressor tanks have been properly drained. 2. Lubricate the tool following these directions: a. Use DeWALT pneumatic tool oil or a non-detergent S.A.E. 20 weight oil. DO NOT use detergent oil or additives as they will damage o-rings and rubber parts. b. Use a filter-regulator-lubricator in the air line between the compressor and the tool when possible. c. If a lubricator is not available, add 5 to 7 drops of oil in the air fitting a least twice a day or every 4 hours of use. 3. Wear proper eye, hearing and respiratory protection. 4. Ensure canister is empty of all fasteners. 5. Check for smooth and proper operation of contact trip and pusher assemblies. Do not use tool if either assembly is not functioning properly. NEVER use a tool that has the contact trip restrained in the up position. 6. Check air supply. Ensure that air pressure does not exceed recommended operating limits, refer to Tool Specifications. 7. Keep tool pointed away from yourself and others. 8. Connect air hose. 9. Check for audible leaks around valves and gaskets. Never use a tool that leaks or has damaged parts. WARNING: To reduce the risk of personal injury, disconnect tool from air supply before performing maintenance, clearing a jammed fastener, leaving work area, moving tool to another location or handing the tool to another person. Loading the Tool (Fig. 2-4) WARNING: Keep the tool pointed away from yourself and others. Serious personal injury may result. WARNING: Never load nails with the contact trip or trigger activated. Personal injury may result. 1. Read all Safety Warnings before using tool. 2. Connect the air supply to the tool. 3. Push the door latch (D) to open the nail FIG. 2 guide door (G). 4. Rotate the canister cover (C) open. 5. Adjust the nail D platform (I) to properly accommodate the nail length being used. • Push the platform C lever (J). G 7