Dell U4025QW UltraSharp 40 Curved Thunderbolt Hub Monitor - Simplified Service - Page 16

Self-test

Get Dell U4025QW PDF manuals and user guides View all Dell U4025QW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

6. Trouble Shooting Instructions WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions. Self-test Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly connected but the monitor screen remains dark, run the monitor self-test by performing the following steps: 1. Turn o both your computer and the monitor. 2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove all digital and the analog cables from the back of the computer. 3. Turn on the monitor. The oating dialog box should appear on-screen (against a black background), if the monitor cannot sense a video signal and is working correctly. While in self-test mode, the power LED remains white. Also, depending upon the selected input, one of the dialogs that are shown below will continuously scroll through the screen. No DP Cable The display will go into Standby Mode in 4 minutes. www.dell.com/U4025QW or No Thunderbolt(140W) Cable The display will go into Standby Mode in 4 minutes. www.dell.com/U4025QW 4. This message also appears during normal system operation if the video cable is disconnected or damaged. 5. Turn o your monitor and reconnect the video cable; then turn on both your computer and the monitor. If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning properly.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
6. Trouble Shooting Instructions
WARNING:
Before you begin any of the procedures in this section, follow
the
Safety Instructions
.
Self-test
Your monitor provides a self-test feature that allows you to check whether your
monitor is functioning properly. If your monitor and computer are properly connected
but the monitor screen remains dark, run the monitor self-test by performing the
following steps:
1.
Turn o± both your computer and the monitor.
2.
Unplug the video cable from the back of the computer. To ensure proper Self-Test
operation, remove all digital and the analog cables from the back of the computer.
3.
Turn on the monitor.
The ²oating dialog box should appear on-screen (against a black background), if the
monitor cannot sense a video signal and is working correctly. While in self-test mode,
the power LED remains white. Also, depending upon the selected input, one of the
dialogs that are shown below will continuously scroll through the screen.
No DP Cable
The display will go into Standby Mode in 4 minutes.
www.dell.com/U4025QW
or
No Thunderbolt(140W) Cable
The display will go into Standby Mode in 4 minutes.
www.dell.com/U4025QW
4.
This message also appears during normal system operation if the video cable
is
disconnected or damaged.
5.
Turn o± your monitor and reconnect the video cable; then turn on both your
computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check your
video controller and computer, because your monitor is functioning properly.