Dell P2720DC Users Guide - Page 26

Setting up the monitor, Attaching the stand

Get Dell P2720DC PDF manuals and user guides View all Dell P2720DC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

Setting up the monitor Attaching the stand NOTE: The stand is detached when the monitor is shipped from the factory. NOTE: This is applicable for a monitor with a stand.If you have purchased a third-party stand refer to the respective stand setup guide for the set up instructions. To attach the monitor stand. 1. Follow the instructions on the flaps of carton to remove the stand from the top cushion that secures it. 2. Insert the stand base blocks fully into the stand slot. 3. Lift the screw handle and turn the screw clockwise. 4. After fully tightening the screw, fold the screw handle flat within the recess. 1 2 3 5. Lift the cover to expose the VESA area for stand assembly. 6. Attach the stand assembly to the monitor. a. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor. b. Press the stand down till it snaps into place. 26 │ Setting up the monitor

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
26
│
Setting up the monitor
Setting up the monitor
Attaching the stand
NOTE: The stand is detached when the monitor is shipped from the
factory.
NOTE: This is applicable for a monitor with a stand.If you have
purchased a third-party stand refer to the respective stand setup
guide for the set up instructions.
To attach the monitor stand.
1.
Follow the instructions on the flaps of carton to remove the stand from the
top cushion that secures it.
2.
Insert the stand base blocks fully into the stand slot.
3.
Lift the screw handle and turn the screw clockwise.
4.
After fully tightening the screw, fold the screw handle flat within the recess.
2
1
3
5.
Lift the cover to expose the VESA area for stand assembly.
6.
Attach the stand assembly to the monitor.
a.
Fit the two tabs on the upper part of the stand to the groove on the back
of the monitor.
b.
Press the stand down till it snaps into place.