D-Link DGS-3000-10TC Hardware Installation Guide - Page 33
DGS-3000 Series, CLI Reference Guide, Boot up display in console screen, Under Properties
View all D-Link DGS-3000-10TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide • Under Properties, select VT100 for Emulation mode. • Select Terminal keys for Function, Arrow and Ctrl keys. Make sure to use Terminal keys (not Windows keys) are selected. NOTE: When using HyperTerminal with the Microsoft® Windows® 2000 operating system, ensure that Windows 2000 Service Pack 2 or later is installed. Windows 2000 Service Pack 2 allows use of arrow keys in HyperTerminal's VT100 emulation. See www.microsoft.com for information on Windows 2000 service packs. • After you have correctly set up the terminal, plug the power cord into the power receptacle on the back of the Switch. The boot sequence appears in the terminal. • After the boot sequence completes, the console login screen displays. • If the user has not logged into the command line interface (CLI) program, press the Enter key at the User name and password prompts. There is no default user name and password for the Switch. The administrator must first create user names and passwords. If user accounts have been previously set up, log in and continue to configure the Switch. • Enter the commands to complete desired tasks. Many commands require administrator-level access privileges. Read the next section for more information on setting up user accounts. See the DGS-3000 Series CLI Reference Guide on the documentation CD for a list of all commands and additional information on using the CLI. • To end a management session, use the logout command or close the emulator program. If problems occur in making this connection on a PC, make sure the emulation is set to VT-100. The emulation settings can be configured by clicking on the File menu in the HyperTerminal window by clicking on Properties in the drop-down menu, and then clicking the Settings tab. This is where you will find the Emulation options. If you still do not see anything, try rebooting the Switch by disconnecting its power supply. Once connected to the console, the screen on the next page will appear on the console. This is where the user will enter commands to perform all the available management functions. The Switch will prompt the user to enter a user name and a password. Upon the initial connection, there is no user name or password and therefore just press Enter twice to access the command line interface. Boot Procedure V1.00.001 Power On Self Test 100 % MAC Address : 00-01-02-03-04-00 H/W Version : A1 Please Wait, Loading V1.00.004 Runtime Image UART init Starting runtime image Device Discovery 100 % 100 % | Figure 4-1 Boot up display in console screen 25