Cisco ATA186-I1 Administration Guide - Page 94

Operational Parameters Chapter 5 Parameters and Defaults OpFlags Description Use this parameter to enable/disable various operational features. See Table 5-4 for bit definitions of this parameter. Value Type Bitmap Default 0x2 Voice Configuration Menu Access Code 323 Related Parameters • TftpURL, page 5-4 • DHCP, page 5-8 • VLANSetting, page 5-11 Table 5-4 OpFlags Parameter Operational Features to Turn On or Off Bit Number Definition 0 If Bit 0 = 0, the TFTP configuration filename supplied by the DHCP server overwrites the default filename for each Cisco ATA. If Bit 0 = 1, the default Cisco ATA filename is always used. Default: 0 1 If Bit 1 = 0, the Cisco ATA probes the static network router during the power-up process. If Bit 1 = 1, static network router probing is disabled. Default: 1 2 Reserved. 3 If Bit 3=1, the Cisco ATA does not request DHCP option 150 in the DHCP discovery message; some DHCP servers do not respond if option 150 is requested. Default: 0 4 If Bit 4 = 1, the Cisco ATA use the VLAN ID specified in the VLANSetting parameter for VLAN IP encapsulation (see the "VLANSetting" section on page 5-11). Default: 0 5 If Bit 5=1, the Cisco ATA disables VLAN IP encapsulation. Default: 0 6 If Bit 6=1, the Cisco ATA does not perform CDP discovery. Default: 0 7 If Bit 7=1, the Cisco ATA does not allow web-based configuration. Default: 0 5-24 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0) OL-4652-01