Cisco ATA186-I1 Administration Guide - Page 67

Chapter 4 Adding the Cisco ATA to the Cisco CallManager Using the Cisco Bulk Administration Tool (BAT) Step 7 Step 8 Step 9 Step 10 Step 11 Step 12 In the Phone Configuration screen, you must enter information in the following fields: • MAC Address -Enter the MAC address of the Cisco ATA. • Device Pool-Select either the Default value or a configured device pool from the drop-down list. • Phone Button Template-From the drop-down list, select Standard 7960 if you are using Cisco CallManager version 3.0 or 3.1; select Standard ATA 186 if you are using Cisco CallManager version 3.2 Click the Insert button (called the Update button in Cisco CallManager version 3.2). The Cisco CallManager Administration application should inform you that the device has been added to the database. You are also asked if you want to assign a directory number for the Phone 1 port at this time. Click OK. In the Directory Number field, assign a directory number to the Cisco ATA. From the Partition drop-down list, you can select a partition for the Cisco ATA or you can keep the default value of None. Click the Insert button (called the Update button in Cisco CallManager version 3.2). A popup window asks you if you want to return to the current-device page. Click OK. To add a second FXS port to Cisco CallManager, go back to Step 3 and proceed from there. You need to fabricate a MAC address for the Phone 2 port by dropping the two left-most digits from the Cisco ATA MAC address and add the digits 01 to the right-most portion of the MAC address. Example If the MAC address of the Cisco ATA is 00070EA26032, then the fabricated MAC address for the Phone 2 port would be 070EA2603201. Note By default, both Cisco ATA FXS ports are enabled for Cisco CallManager registration. If you do not want to add the Phone 2 FXS port to Cisco CallManager, you must change the Cisco ATA EPID1orSID1 parameter value to 0 to disable the Phone 2 port. (To disable the Phone 1 port, you must change the EPID0orSID0 parameter value to 0.) Using the Cisco Bulk Administration Tool (BAT) The Cisco Bulk Administration Tool (BAT) is a plug-in application for Cisco CallManager that enables system administrators to perform batch operations, including registration, on large numbers of Cisco IP Phones and Cisco ATAs. Refer to the Bulk Administration Tool Guide for Cisco CallManager for instructions on using BAT to add Cisco ATAs to the Cisco CallManager. OL-4652-01 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0) 4-3