Cisco 2811 Hardware Guide - Page 155
Verifying AIM Installation, show version, show diag 0 - vpn configuration example
![]() |
UPC - 882658101816
View all Cisco 2811 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Figure 27 Example of an AIM Label Location on a Chassis AIM-VPN/EP II Installing and Removing AIMs 35622 Rear of chassis AIM label Verifying AIM Installation Use the show version command to verify that the AIM has been installed correctly. In the following example, one VPN AIM is recognized by the system. (See the bold entry toward the bottom of the example. Note that you will see additional output not shown in this example.) Router# show version Cisco IOS Software, 2800 Software (C2800-ADVENTERPRISEK9-M), Experimental Versio n 12.3(20040521:041814) [pgynther-v123_8_t_throttle 107] Copyright (c) 1986-2004 by Cisco Systems, Inc. Compiled Fri 21-May-04 00:35 by pgynther ROM: System Bootstrap, Version 12.3(8r)T1, RELEASE SOFTWARE (fc1) sjc22-00a-fs-gw2 uptime is 2 days, 16 hours, 17 minutes System returned to ROM by reload at 17:57:37 PDT Sat Jun 26 2004 System restarted at 17:58:51 PDT Sat Jun 26 2004 System image file is "flash:c2800-adventerprisek9-mz.123-8T-2" . . . Cisco 2851 (revision 53.51) with 196608K/65536K bytes of memory. Processor board ID FHK0817F02Q 45 FastEthernet interfaces 5 Gigabit Ethernet interfaces 1 Virtual Private Network (VPN) Module 12 Voice FXS interfaces DRAM configuration is 64 bits wide with parity disabled. 239K bytes of non-volatile configuration memory. 62720K bytes of ATA CompactFlash (Read/Write) Configuration register is 0x2102 Use the show diag 0 command to obtain hardware information about an installed AIM. You will see additional output that is not shown in these examples. OL-5792-04 Installing and Upgrading Internal Modules in Cisco 2800 Series Routers 27
![](/manual_guide/products/cisco-2811-hardware-guide-c33e08d/155.png)