Canon LX-MW500 User Manual - Page 56
Using the Network Function when the projector is in standby mode, Glossary, Standby LAN
![]() |
View all Canon LX-MW500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
• The above-mentioned control may not be performed correctly or the monitoring data may not be obtained correctly in the following conditions: • During standby • During input source switching • During command processing • During AUTO PC execution • Before the splash screen disappears after the power is turned on. • Use 1 computer to control/monitor 1 projector. • For how to control/monitor using PJLink™, see the operation manual of the PJLink™ application you use. • When you monitor the projector's operating state using this function by issuing inquiry commands successively, issue an inquiry command after receiving the response to the previous inquiry command from the projector. Using the Network Function when the projector is in standby mode When the Standby LAN in the SYSTEM SETUP: Advanced > LAN Settings menu is activated, the projector is able to provide the network function when it is in standby mode. Glossary For more detail of the glossary below, refer to the technical book that is commercially available. Term DHCP IP Address Subnet Mask Default Gateway Description Abbreviation for Dynamic Host Configuration Protocol. This protocol automatically assigns IP Address to networked devices. Numerical address to identify networked computers. A numeric value to define the number of bits used for a network address of a divided network (or subnet) in an IP Address. A server (or router) to communicate across networks (subnets) that are divided by Subnet Mask. 56
![](/manual_guide/products/canon-lxmu500-user-manual-9b0bf5b/56.png)