Bosch SHS863WD5N Use and Care Manual - Page 43

Troubleshooting en-us Dishes not dry. Rinse aid dispenser 9* is empty Add rinse aid or adjust setting - the use of or incorrect rinse aid amount is set. rinse agent improves drying, use the Auto cycle, use the Sanitize option. Extra Dry heat option not chosen.* Activate Extra Dry heat option.* Water collected in depressions on Arrange dishes in upper rack to slope so the dishes and silverware. water can drain. Door was opened or dishes removed before wash cycle was completed. Wait until wash cycle ends before opening door or removing dishes. Plastics don't absorb heat like cut- Use more intensive wash cycles (with hotter lery or china and don't dry as well. rinse water) or activate Extra Dry heat option.* Silverware not arranged properly in Arrange silverware properly and separate the silverware basket or top rack. them so they don't contact each other. Odor Note: Water testing is done in the factory. Occasionally water may still appear in dishwasher at purchase which may create an odor. Food debris in the dishwasher sump and door seal. Food debris left on dishes too long. Not using rinse aid or using improper detergent. Residual standing water in the sump. Drain line is clogged or drain hose is kinked, clogged or blocked. Or drain hose was not installed with a high loop. Clean sump filters, sump and door seal as needed. ~ "Care and Maintenance" on page 35 Run dishwasher more frequently. Use rinse aid and the proper detergent. Make sure previous wash cycle has finished. Unclog drain line or replace drain hose. Be sure drain hose is installed with high-loop. Note: If odor still persists, run the Normal/ Regular cycle until it flushes and interrupt the cycle and place an 8 oz. cup of distilled white vinegar solution on the upper rack and then finish the cycle. Dishwasher isn't filling with water (or "Check water supply" display occurs) Water supply hose is kinked. Previous wash cycle was not completed or current wash cycle was interrupted. Delay start or Child lock may be activated. Install new supply hose (without kinks). Complete wash cycle or reset dishwasher. Reset Delay start or Child lock functions (refer to the appropriate sections in this manual). Water supply line is clogged. Unclog water line. Water supply was turned off. Turn on water supply. Fascia panel is Panel was cleaned with discolored or bleach-based wipes or abrasive scratched. cleaners/cleaning pads. Use mild detergents with soft damp cloth. 43