Bosch NGM8656UC Installation instructions - Page 11
Burner Cap and Burner Base Placement, Placing Burner Caps and Bases, Checking Burner Cap Placement
View all Bosch NGM8656UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Burner Cap and Burner Base Placement Checking Burner Cap Placement ▯ After electrical connection is complete, place each burner base on the corresponding location on the cooktop. One of the three bars on the burner base should line up with the notch and prevent the base from rotating. The small hole or cutout near the edge should also line up with the igniter. Pay special attention to avoid damaging the igniter during installation of the base. See Illustration below. ▯ Once each base is located and resting evenly, place each burner cap on its correct burner base. See Illustration. ▯ Place burner cap gently on top of base so that the prongs of the burner base fit snugly into the groove of the burner cap. ▯ If the maintop is removed by a certified installer (for example to check electrical or piping connection) the panhead screws that were removed must be reinstalled to ensure proper functionality of burners. 1 2 ▯ Check to make sure that there is no gap between the burner cap and burner base. See illustration below for correct and incorrect placements of the burner cap. ▯ You may gently try to move the burner cap from side to side to check if it is properly placed. If properly placed, the cap will click from side to side as the prongs hit the groove ridge. Checking Burner Cap Placement Placing Burner Caps and Bases 11
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40