Black & Decker BDASP103 Instruction Manual - Page 13

Maintenance And Care - Replace Brush Roll WARNING: Turn off and unplug vacuum cleaner before performing maintenance to the vacuum cleaner. You should check your cleaner's brush roll and drive belt regularly for wear or damage. You should also clean the brush and brush ends by removing string, hair and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the brush cover. 1. Turn off vacuum and unplug from electrical outlet. 2. Place vacuum upside down with brush roll facing upwards. 3. Remove the six screws as shown with a small Phillips screwdriver. 4. Lift off brush cover. 5. Grasp floor brush at both ends and remove by lifting out. 6. Clean string, hair and other debris from floor brush, motor pulley, and drive belt. 7. Check floor brush for worn areas and replace if needed. 8. Check air passageway for obstructions. Remove debris from this area. 9. When finished cleaning, reposition floor brush and drive belt. Then replace the brush cover and re-install the five screws. 10. Turn floor brush by hand several times in the direction of the motor pulley. If properly installed, the drive belt will align itself on floor brush. 1 2 3 Remove Six Screws 4 5 13