BenQ GW2480 User Manual - Page 20

2. Remove the cover of the cable management system. The stand arm also works as a cable management system that helps keep the cables neat and clean. Slide the cable cover up to align the marking on the cable cover with the unlock icon on the stand arm. Remove the cover as illustrated. You can have one power cord, two video cables, and one audio cable routed together. Pass a cable through the cable management hole on the stand arm first while cabling. Start with the ones with bigger connectors. Allow enough cable length while cabling to avoid loose connection and to save the pins or socket connectors from being bent or broken. 3. Connect the power cable to the monitor. Pass the cable through the cable management hole on the stand arm first. Plug one end of the power cord into the socket labelled on the rear of the monitor. Do not connect the other end to a power outlet just yet. 4. Connect the PC video cable Do not use both DVI-D cable and D-Sub cable on the same PC. The only case in which both cables can be used is if they are connected to two different PCs with appropriate video systems. To Connect the DVI-D Cable Pass the cable through the cable management hole on the stand arm first. Connect the plug of the DVI-D cable (at the end without the ferrite filter) to the monitor video socket. Connect the other end of the cable (at the end with the ferrite filter) to the computer video socket. Tighten all finger screws to prevent the plugs from accidently falling out during use. 1 2 Either D-SUB LINE IN 20 How to assemble your monitor hardware (for models without height adjustment stand)