BenQ EX3501R User Manual - Page 12

Connect the headphone., Connect USB devices., Connect the power adapter to the monitor.

Get BenQ EX3501R PDF manuals and user guides View all BenQ EX3501R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

5. Connect the headphone. Pass the cable through the cable management hole on the stand arm first. You may connect headphones to the headphone jack found on the back side of the monitor. 6. Connect USB devices. Connect USB devices via other USB ports (downstream) on the monitor. These downstream USB ports transmit data between connected USB devices and the upstream port (USB-C™). The USB hubs (downstream ports) are available only when the USB-C™ port is in use. 7. Connect the power adapter to the monitor. Pass the cable through the cable management hole on the stand arm first. Connect the power adapter to the socket labelled on the rear of the monitor. Do not connect the other end to a power outlet just yet. 8. Install the back cover. Align the back cover with the holes on the back of the 1 monitor ( ), and press the sides and the bottom of the back cover against the holes to lock it into place as 2 illustrated ( ). Push from the bottom of the cover and check if the it has been installed properly. To remove the back cover, see How to change cable connection after initial installation on page 15 for more information. 12 How to assemble your monitor hardware

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
12
How to assemble your monitor hardware
5. Connect the headphone.
Pass the cable through the cable management hole on
the stand arm first.
You may connect headphones to the headphone jack
found on the back side of the monitor.
6. Connect USB devices.
Connect USB devices via other USB ports
(downstream) on the monitor. These downstream USB
ports transmit data between connected USB devices
and the upstream port (USB-C™).
The USB hubs (downstream ports) are available only when
the USB-C™ port is in use.
7. Connect the power adapter to the monitor.
Pass the cable through the cable management hole on
the stand arm first. Connect the power adapter to the
socket labelled
on the rear of the monitor. Do not
connect the other end to a power outlet just yet.
8. Install the back cover.
Align the back cover with the holes on the back of the
monitor (
), and press the sides and the bottom of
the back cover against the holes to lock it into place as
illustrated (
). Push from the bottom of the cover and
check if the it has been installed properly.
To remove the back cover, see
How to change cable
connection after initial installation on page 15
for more
information.
1
2