Belkin F1DD104L User Manual - Page 21

Connect your KVM Switch to the Host PC - cables extension

Get Belkin F1DD104L - SOHO KVM Switch DVI PDF manuals and user guides
UPC - 722868120019
View all Belkin F1DD104L manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

section Firmware-Upgrade Guide Connect your KVM Switch to the Host PC 1 Step 5. Now press the first front-panel button on the KVM Switch until you hear 2 three beeps. The KVM Switch has now entered into the upgrade mode. Step 6. 3 Check to make sure the KVM cables from port 1 are connected to the host PC. 4 Note: A special upgrade cable is not needed to perform the upgrade since you can use the same KVM cable that you use for connecting to the computers. However, depending on the different models, the KVM cables you use will vary. 5 Step 7. 6 Click the "Browse" button and locate the firmware-upgrade file, which is indicated with a file extension such as "*.blk". 7 8 Select the upgrade file (for example: "UCF-30-11-07.blk") and click "Open" to load the file. Then click "Upgrade" to make it ready for upload. 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
19
1
2
3
4
5
6
7
8
section
Firmware-Upgrade Guide
Connect your KVM Switch to the Host PC
Step 5.
Now press the first front-panel button on the KVM Switch until you hear
three beeps. The KVM Switch has now entered into the upgrade mode.
Step 6.
Check to make sure the KVM cables from port 1 are connected to the host PC.
Note:
A special upgrade cable is not needed to perform the upgrade since you can
use the same KVM cable that you use for connecting to the computers. However,
depending on the different models, the KVM cables you use will vary.
Step 7.
Click the “Browse” button and locate the firmware-upgrade file, which is indicated
with a file extension such as “*.blk”.
Select the upgrade file (for example: “UCF-30-11-07.blk”) and click “Open” to load
the file. Then click “Upgrade” to make it ready for upload.