Ariens Deluxe 28 Owners Manual - Page 24

MAINTENANCE Ariens Dealers will provide any service or adjustments which may be required to keep your unit operating at peak efficiency. Should engine service be required, contact an Ariens dealer or an authorized engine manufacturer's service center. WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding. SERVICE POSITION (Figure 24) WARNING: Before tipping unit up onto housing, remove fuel so no spills will occur. Ensure unit is secure and will not tip over during maintenance. 1. Shut off engine, remove key, disconnect spark plug wire and allow unit to cool completely. 2. Close fuel shut-off valve (see Fuel ShutOff Valve on page 21) or (see on page 21). 3. Drain fuel tank and fuel system (see Engine Manual for complete instructions). 4. Place unit on a flat level surface. Tip unit forward onto front of auger housing for service. IMPORTANT: Ensure unit is secure and will not tip over. Strap and clamp onto bench if needed. Service Position MAINTENANCE SCHEDULE The chart below shows the recommended maintenance schedule that should be performed on a regular basis. More frequent service may be required. MAINTENANCE SCHEDULE Service Performed Each Every Every Yearly Use 5 hrs. 25 hrs. Check Dual • Handle Interlock Check • Fasteners Check Clutch • Operation Check Clutch Cable Adjustment *• Clean Engine • Check Engine • • Oil Change Engine Oil** Check Tire • Pressure Check Auger Gearcase • • General Lubrication • • *After first five hours of operaion. ** Refer to Engine Manual for detailed instructions CHECK DUAL HANDLE INTERLOCK Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. CHECK FASTENERS Make sure all hardware is tightened properly. Figure 24 EN - 24