Adaptec AHA-1540 User Manual - Page 8
especially
View all Adaptec AHA-1540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Section Three Installation 3.3.4 AT BIOS Address The starting address of the block of address space reserved for the Adaptec BIOS is selected by the jumper pins located in J10. This jumper set is located just above the large AT bus connector. The default address is ODCOOOH. This address must not conflict with any other BIOS in the system. AT BIOS Address Pin Pair 12 3 X- X -- X X- -- - BIOS Address 0C8000H 0 D8000H 0CC000H 0DC000H J1 0 0 0 0 0 00 Pin Pair 1 X = Jumper Installed 3.3.5 AT BIOS Wait State Accesses to the Adaptec BIOS can have one wait state added by installing the jumper located at J4. This jumper set is located to the left of the SCSI terminator RN7. The default is no wait state. 3.3.6 Reserved Jumpers The jumper, pin pair 2 located in jumper block Jl, is reserved for Adaptec use only and must not have any jumper shunts installed. If this jumper is installed, normal operation is prevented. Default is no jumper installed. 3.3.7 LA Enable Jumper Note: Some computers, especially 80386 based machines, short address lines LA17 and SA17, LA18 and SA18, and LA19 and SA19 together. If your computer system shorts these lines then remove jumper J5. Default is jumper installed. Warning: Incorrect installation of this jumper may not result in immediate system problems. If it is necessary to change the state of this jumper after the system has been configured, the SCSI hard disk must also be re-formatted. Contact your system manufacturer if in doubt on how your system implements these address lines. AHA-1540 3- 7 adaptec