AEG T8DBG842R User Manual - Page 17

Emptying the water, container, Cleaning the condenser

Get AEG T8DBG842R PDF manuals and user guides View all AEG T8DBG842R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

ENGLISH 17 If the condensed water container is full, the programme stops automatically. The Tank symbol comes on the display and you must empty the water container. To empty the water container: 1. Pull the water container out keeping it in a horizontal position. 3. Use a moist hand to clean both parts of the filter. 2. Pull the plastic connection out and drain the water into a basin or equivalent receptacle. 4. If necessary, clean the filter with a vacuum cleaner. Close the filter. 5. If necessary, remove fluff from the filter socket and gasket. You can use a vacuum cleaner. Place the filter back inside the filter socket. 10.2 Emptying the water container Empty the condensed water container after each drying cycle. 3. Push the plastic connection back in and place the water container back into position. 4. To continue the programme press the Start/Pause button. 10.3 Cleaning the condenser If the symbol Condenser flashes on the display, inspect the condenser and its compartment. If it is dirty, clean it. Do the check not less than once a 6 months. WARNING! Do not touch the metal surface with bare hands. Risk of injury. Wear protective gloves. Clean carefully to avoid damaging the metal surface. To inspect:

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
3.
Use a moist hand to clean both parts
of the filter.
4.
If necessary, clean the filter with a
vacuum cleaner. Close the filter.
5.
If necessary, remove fluff from the
filter socket and gasket. You can use
a vacuum cleaner. Place the filter
back inside the filter socket.
10.2
Emptying the water
container
Empty the condensed water container
after each drying cycle.
If the condensed water container is full,
the programme stops automatically. The
Tank
symbol comes on the display
and you must empty the water container.
To empty the water container:
1.
Pull the water container out keeping
it in a horizontal position.
2.
Pull the plastic connection out and
drain the water into a basin or
equivalent receptacle.
3.
Push the plastic connection back in
and place the water container back
into position.
4.
To continue the programme press
the Start/Pause button.
10.3
Cleaning the condenser
If the symbol
Condenser
flashes on
the display, inspect the condenser and
its compartment. If it is dirty, clean it. Do
the check not less than once a 6 months.
WARNING!
Do not touch the metal
surface with bare hands. Risk
of injury. Wear protective
gloves. Clean carefully to
avoid damaging the metal
surface.
To inspect:
ENGLISH
17