2012 Yamaha Motorsports Big Bear 400 4x4 IRS Owners Manual - Page 95
2012 Yamaha Motorsports Big Bear 400 4x4 IRS Manual
Page 95 highlights
engine oil drain bolt, be sure to install the O-ring, compression spring and oil strainer. [ECB00321] Tightening torque: Engine oil drain bolt: 32 Nm (3.2 m·kgf, 23 ft·lbf) 12. Refill with the specified amount of the recommended engine oil, and then install and tighten the engine oil filler cap. Recommended oil: See page 10-1. Oil quantity: Without oil filter element replacement: 2.90 L (3.07 US qt, 2.55 Imp.qt) With oil filter element replacement: 3.00 L (3.17 US qt, 2.64 Imp.qt) TIP Be sure to wipe off spilled oil on any parts after the engine and exhaust system have cooled down. ECB00300 NOTICE G In order to prevent clutch slippage (since the engine oil also lubricates the clutch), do not mix any chemical additives. Do not use oils with a diesel specification of "CD" or oils of a higher quality than specified. In addition, do not use oils labeled "ENERGY CONSERVING II" or higher. G Make sure that no foreign material enters the crankcase. 13. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. 14. Turn the engine off, wait at least ten minutes, and then check the oil level and correct it if necessary. EBU28564 8 Final gear oil The final gear case must be checked for oil leakage before each ride. If any leakage is found, have a Yamaha dealer check and repair the ATV. In ad- 8-15