2010 Yamaha Motorsports V Star 650 Custom Owners Manual - Page 75
2010 Yamaha Motorsports V Star 650 Custom Manual
Page 75 highlights
PERIODIC MAINTENANCE AND ADJUSTMENT EAU24283 Replacing a turn signal light bulb or the tail/brake light bulb 1. Remove the lens by removing the screws. XVS65AZ/XVS65ATZ EAU24350 Supporting the motorcycle Since this model is not equipped with a centerstand, follow these precautions when removing the front and rear wheel or performing other maintenance requiring the motorcycle to stand upright. Check that the motorcycle is in a stable and level position before starting any maintenance. A strong wooden box can be placed under the engine for added stability. To service the front wheel 1. Stabilize the rear of the motorcycle by using a motorcycle stand or, if an additional motorcycle stand is not available, by placing a jack under the frame in front of the rear wheel. 2. Raise the front wheel off the ground by using a motorcycle stand. To service the rear wheel Raise the rear wheel off the ground by using a motorcycle stand or, if a motorcycle stand is not available, by placing 1. Screw 1. Screw XVS65Z 2. Remove the burnt-out bulb by pushing it in and turning it counterclockwise. 3. Insert a new bulb into the socket, push it in, and then turn it clockwise until it stops. 4. Install the lens by installing the screws. NOTICE: Do not overtighten the screws, otherwise the lens may break. [ECA10681] 7 1. Screw 7-34