2010 Yamaha Motorsports Roadliner S Owners Manual - Page 31
2010 Yamaha Motorsports Roadliner S Manual
Page 31 highlights
INSTRUMENT AND CONTROL FUNCTIONS To release the helmet from the helmet holder Remove the rider seat, remove the helmet holding cable from the helmet holder and the helmet, and then install the seat. EAU38405 Adjusting the shock absorber assembly This shock absorber assembly is equipped with a spring preload adjusting nut. ECA10101 NOTICE To avoid damaging the mechanism, do not attempt to turn beyond the maximum or minimum settings. Adjust the spring preload as follows. load and thereby soften the suspension, turn the adjusting nut in direction (b). G To make the adjustment, use the special wrench and extension bar included in the additional tool kit, which was handed out separately at the purchase of the vehicle. G The spring preload setting is determined by measuring distance A, shown in the illustration. The shorter distance A is, the higher the spring preload; the longer distance A is, the lower the spring preload. With each complete turn of the adjusting nut, distance A is changed by 2.0 mm (0.08 in). 4 1. Locknut 2. Spring preload adjusting nut 1. Loosen the locknut. 2. To increase the spring preload and thereby harden the suspension, turn the adjusting nut in direction (a). To decrease the spring pre4-15