2010 Yamaha Motorsports Phazer GT Owners Manual - Page 32
2010 Yamaha Motorsports Phazer GT Manual
Page 32 highlights
Control functions 1. Shock absorber pump 1. Air valve cap To adjust the air pressure EWS00621 4. WARNING Support the snowmobile securely on a suitable stand before adjusting the shock absorbers. Otherwise, the snowmobile could fall and cause injury. ECS00710 Install the hose connector of the shock absorber pump onto the air valve of the shock absorber and tighten it approximately six turns until the pressure registers on the pump gauge. NOTICE: Do not overtighten the connector onto the air valve as this will damage the connector seal. [ECS00721] NOTICE Make sure that there is no load on the shock absorbers and that they are fully extended before making any air pressure adjustments. 1. 2. Place the snowmobile on a level surface and apply the parking brake. Lift the front of the snowmobile onto a suitable stand to raise the skis off the ground. Remove the air valve cap from the shock absorber. 1. Hose connector 3. TIP If the shock absorber has no air pressure, the gauge reading will be zero. 5. To increase the air pressure, operate the pump a few times. The pressure should increase slowly. If the pressure increases rapidly, check to make sure that the pump is properly connected and tightened onto the air valve. To decrease the 26