2010 Yamaha Motorsports Grizzly 700 4x4 Owners Manual - Page 51
2010 Yamaha Motorsports Grizzly 700 4x4 Manual
Page 51 highlights
G G The drive select lever is in the neutral or park position. The rear brake lever or brake pedal is applied with the drive select lever in any position. However, it is recommended to shift into the neutral or park position before starting the engine. EBU20441 Operating the drive select lever and driving in reverse ECB00170 3. Apply the rear brake lever or brake pedal. 4. Completely close the throttle lever and start the engine by pushing the start switch. NOTICE: For maximum engine life, never accelerate hard when the engine is cold! [ECB00162] NOTICE Before shifting, stop the ATV, otherwise the transmission may be damaged. Shifting: Neutral to High-range and High-range to Low-range 1. Bring the ATV to a complete stop. 2. Apply the brake pedal, and then shift by moving the drive select lever along the shift guide. TIP Make sure that the drive select lever is completely shifted into position. 6 TIP If the engine fails to start, release the start switch, then push it again. Pause a few seconds before the next attempt. Each cranking should be as short as possible to preserve battery energy. Do not crank the engine more than 10 seconds on each attempt. 6-2