2009 Yamaha Motorsports Venture Lite Owners Manual - Page 37
2009 Yamaha Motorsports Venture Lite Manual
Page 37 highlights
Control functions Spring preload setting: Minimum (soft): S Standard: M Maximum (hard): H ESU13092 Adjusting the 2-up adjusting blocks (PZ50VT) EWS00760 WARNING Make sure that the 2-up adjusting blocks are installed in the same position on both sides of the snowmobile, otherwise poor handling and loss of stability may result. The spring force can be adjusted by changing the position of the 2-up adjusting blocks. 1. 2. 3. 4. 2-up position (rider and passenger) Solo rider position Special tool Lock pin 2. 3. 4. Pull the lock pin and turn the special tools to change the block position. Release the lock pin. Remove the special tools from the 2-up adjusting block. ESU11022 Adjusting the compression damping force of the rear shock absorber (PZ50RT) The compression damping force can be adjusted by turning the adjusting screw. To increase the compression damping force, turn the adjusting screw in direction (a). To decrease the compression damping force, turn the adjusting screw in direction (b). NOTICE: Do not continue to turn the adjusting screw in direction (a) after it stops. The shock absorber could be damaged and damping force adjustments will not be able to be made. Do not turn the adjusting screw in direction (b) more than 20 click(s). Even if the adjusting screw is continually turned after 20 click(s), there will be no change in the damping force. Be sure to stop the adjusting screw at a position where there is a click. [ECS00301] 1. 2-up adjusting block TIP G G Be sure to make this adjustment when there is no load (rider or cargo) on the snowmobile. Use the special tools included in the owner's tool kit to make the adjustment. Insert the special tools into the 2-up adjusting block as shown. 1. 31