2009 Yamaha Motorsports Grizzly 700 FI Auto. 4x4 EPS Ducks Unlimited Edition O - Page 115

TIP If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4-1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as soon as possible. 4. Install the spark plug cap. EBU27462 Engine oil and oil filter cartridge 1. Spark plug gap 2. Clean the surface of the spark plug gasket and its mating surface, and then wipe off any grime from the spark plug threads. 3. Install the spark plug with the spark plug wrench, and then tighten it to the specified torque. Tightening torque: Spark plug: 12.5 Nm (1.25 m·kgf, 9.0 ft·lbf) The engine oil level should be checked before each ride. In addition, the oil must be changed and the oil filter cartridge replaced at the intervals specified in the periodic maintenance and lubrication chart. To check the engine oil level 1. Place the ATV on a level surface. 2. Check the engine oil level on a cold engine. TIP If the engine was started before checking the oil level, be sure to warm up the engine sufficiently, and then wait at least 10 minutes until the oil settles for an accurate reading. 3. Remove panel F. (See page 8-8.) 8-22 8